wrote: My question has nothing to do with the Mute/TV.
I just need to know where the Input/Source button is so I can go back to HDMI instead of being on Ch 03.
Thanks,
Rizzo
This should help!
The Video Source button on the bottom lower-left of the remote IS the same as the Input Select Button. Assuming that you have the codes for your TV programed in to your Spectrum Remote for TV on/off Mute, you need them for the Video Source (Input Select) button to work.
1.) To use the Input Select button, you will need to have the correct codes for your TV On/Off programed into this or any other CATV remote.
2.)The next thing that you need to do is before hitting the Video Source (input Select) button is you MUST press the TV button on your remote first. (Not the Power or System button, just the TV button.)
OP's remote video source button for his remote model, is on the bottom lower left side, This also controls the Input Selection for what you want your TV to do, Remember that it must be set to CATV or STB in order for a cable picture to show.
Quick Instructions for Controlling Video Source (TV Input) Button
1.) With TV on and TV codes programed into remote, press the cable remote TV button.
2.) Press the Video Source (Input Select) button (on lower left side.)
3.) The TV Selection Input Screen from your TV Menu SHOULD show on screen.
4.) Press The Video Source button until you get to the Input TV setting that you want. When you want to go back to watching Cable TV you will have to press the Video Source button to cycle through and get to the setting that will say CABLE TV or CABLE STB After a few seconds, the cable picture will come back.
5.) To get the Video Source/Input Select Menu off your screen, just press your volume up/down button
Important- If you don't have the codes for your TV for on/off MUTE functionality programmed into your CATV remote, AND you also don't press the TV button first, if the video source button does not work, than the video source button will not work!
This should help!
Satch